Search results

Did you install the drivers that was in the folder ? CDM+v2.12.14+WHQL+Certified

If it says micro connect in device manager then it is programmed , do you see that under com port and usb settings ?

The St Micro apps are 32 bit applications , not designed to work on a 64 bit system. best you use XP or win7 32 bit

1. The power should be connected to the mag box 2. Hard to say if they are in the correct place as you have not shown the link from PCB to MAG250 3. PCB should have the 5v jumper set. Looking at your screenshots it looks like you have not programmed the board with the .EPT file as it does...

The guide is for clones , but should work on genuine bricked boxes as well. You can normally tell the clone from the mac address , as it should/could have the same numbering as the serial # On the original boxes it looks like there is a 2nd copy of the bootloader on the 1Mb NOR flash , now...

@Camdtv .. apologies on your first pics the one side will all be odd numbers and the other side will be evens 1.3.5.7.9.11.13.15.17.19 2.4..6.8.10.12.14.16.18.20 so the ones you refer to as 20,19,18 are actually 20.18.16 which is your TX,RX &Gnd on the opposite side will be the JTAG side...

@Camdtv - Yes your numbering is correct. @davetv - There is no 64bit version. @sandy 22 & @Mikeios If your server is updating your box , you should be able to see it updating the minute you connect to your server (If your server does this)

Well the standard seems to be 1-3 days , so if it lasts longer than that you should be fine.

Make sure you are using a decent USB stick , in the mag250 folder on the usb stick do you have the bootstrap as well as the firmware image ?

That programmer should work as it accepts JTAG and UART , Personally don't see the need for the connector and ribbon cable unless you are doing multiple boxes , would personally just solder a few leads on to both sides...

Yeah , load the R19 public image first , then it should accept this one that i uploaded, that is how i did it.

Just need to wait and see now... the process i followed for these devices was similar to yours , i revived the box then updated to the R19 public image , but then i updated to this one , and the box has remained stable.

Revive the box and flash with this firmware image and let me know if the box remains stable. https://www.sendspace.com/file/9klzuo

You need to use a hex editor not notepad.

The problem you have is your are only fixing the bootloader , you need to reflash the older firmware that does not contain the clone killer image.

That should not matter once you load the EPT file from the folder ,you will then re-program your device to what it needs to be.

Gents , this is a very easy mode to do , the ribbon cable connector is not essential , you can just solder your needed wires to the programmer and pin-outs on the board, the rest of the Jtag and serial method is pretty straight forward.