I tried to load an old version and disabled the update and loaded the noblock update. however on reboot it still pushed the new update. I believe it may be because I have the mag324w2 model and not the mag324? Are the models the same firmware wise?
I can get the latest in this location
http://update.infomir.com/mag/324/imageupdate
Can't seem to find the old version on the wiki. I can go into the archive but it shows russian docs.
Do you mean I should download the original image and try this out? I am on a factory updated image now. I think I should push an old version and then block and then do the no block ?
For example when I'm waiting a VOD, the program plays and then hangs and thats the end of it. I have to restart and have it continue. I've increased the buffer but it has the same issue. I know its the provider but shouldnt' the box have a retry reget protocol etc. ? I have the formuler z8 which...
Hi all. Is there a way or a trick to resume from a micro freeze on a playback,. Essentially once it freezes, I have to go back to home and restart the program and then forward till the point. I would have hoped the box would pick it up and resume? Is there a setting somewhere for this?
Thanks. I'm then confused as to what is to be done. For now I am using an alternate Url to make things work :(
I also find the box freezing at times but then post the freeze the program does not continue automatically until a manual intervention is done by exiting and reentering the show.
I...
Is there a way to ssh into the box and disable the update. I just loaded up the noblock and it reupdated it on boot. even after the update is set to no.
No Issues. I believe it may be a bug with the mag box since its the w2 version. I tried to look extensively for the non w2 version as I didn't need the wifi connectivity but couldn't find it.
I have tried that and when I remove the ethernet it boots just fine without the update. however when I put the ethernet the update starts.
I've also ensured the auto update is set to disable. :(
Once No Block is updated, I do see it as the firmware. If you see the screenshot , it shows updating from noblock to the new firmware. Do you think its because it is the 324w2 model?
Hi everyone. I hope someone can help. I just got the mag324w2/325w2
I've gone to recovery mode and loaded the NOBLOCK_324 file successfully, however during reboot it does an auto-update to 2.20.08r2-324
I've attached the screenshots.
I have disabled auto update and also changed the auto update...